EN IS0 27548 EUROPEANSTANDARD NORME EUROPEENNE EUROPAISCHE NORM July 2024 ICS13.040.30;13.100;25.030 English Version Additive manufacturing of plastics - Environment, health and safety - Test method for determination of particle and chemical emission rates from desktop material extrusion 3Dprinter (IS027548:2024) Fabrication additive de plastiques - Environnement, Additive Fertigung von Kunststoffen - Umwelt, sante et securité - Méthode d'essai pour la Gesundheit und Sicherheit - Prifverfahren zur determination des taux d'emission de particules et de Bestimmung der Partikelemissionsrate und der produits chimiques des imprimantes 3D de bureau par chemischen Emissionsrate von extrusion de materiau (IS0 27548:2024) materialextrusionsbasierten Desktop-3D-Druckern (IS0 27548:2024) This European Standard was approved by CEN on 6 July 2024. European Standard the status of a national standard without any alteration.Up-to-date lists and bibliographical references concerning such national standards may be obtained on application to the CEN-CENELEC Management Centre or to any CEN member This European Standard exists in three official versions (English, French, German). A version in any other language made by Centre has the same status as theofficialversions. CEN members are the national standards bodies of Austria, Belgium, Bulgaria, Croatia, Cyprus, Czech Republic, Denmark, Estonia, Finland, France, Germany, Greece, Hungary, Iceland, Ireland, Italy, Latvia, Lithuania, Luxembourg, Malta, Netherlands, Norway, Poland, Portugal, Republic of North Macedonia, Romania, Serbia, Slovakia, Slovenia, Spain, Sweden, Switzerland, Turkiye and United Kingdom ce EUROPEAN COMMITTEE FOR STANDARDIZATION COMITE EUROPEEN DENORMALISATION EUROPAISCHES KOMITEEFUR NORMUNG CEN-CENELEC Management Centre: Rue dela Science23, B-1040Brussels @2024CEN All rights of exploitation in any form and by any means reserved Ref. No. EN IS0 27548:2024 E worldwidefor CEN national Members EN IS027548:2024 (E) Contents Page European foreword. ..3 2 ENIS027548:2024 (E) European foreword This document (ENIS027548:2024) has been prepared by Technical CommitteeIS0/TC 261"Additive manufacturing"in collaboration with Technical Committee CEN/TC 438"Additive Manufacturing"the secretariat of which is held by AFNOR. This European Standard shall be given the status of a national standard, either by publication of an identical text or by endorsement, at the latest by January 2025,and conflicting national standards shall bewithdrawnatthelatestbyJanuary2025. Attention is drawn tothepossibility that some of the elements of this document maybe the subject of patent rights. CEN shall not be held responsible for identifying any or all such patent rights. Any feedback and questions on this document should be directed to the users' national standards body/national committee.A completelistingofthesebodies can befound on theCENwebsite. According to the CEN-CENELEC Internal Regulations, the national standards organizations of the following countries are bound to implement this European Standard:Austria, Belgium, Bulgaria, Croatia, Cyprus, Czech Republic, Denmark, Estonia, Finland, France, Germany, Greece, Hungary, Iceland Ireland, Italy, Latvia, Lithuania, Luxembourg, Malta, Netherlands, Norway, Poland, Portugal, Republic of North Macedonia, Romania, Serbia, Slovakia, Slovenia, Spain, Sweden, Switzerland, Turkiye and the United Kingdom. Endorsement notice The text ofIS0 27548:2024 has been approved by CENas ENIS027548:2024 without any modification 3